Set a node as an entrypoint

If you set a node as an entry point in the dialog, then this node can be jumped to via the node Go To, so that the dialog is continued from this point.

TIP

info

Number of Entry Points

You can set any number of nodes as entry points.

To set a node as an entrypoint to the dialog:

  1. To set a node as an entrypoint to the dialog, under Chart click on the node you want to use as an entrypoint.
  2. The configuration window opens.
  3. Click on the three dots in the configuration window.
  4. or
    Under Chart right-click the node you want to set as an entrypoint.
  5. The node menu opens.
  6. Click on Set Entrypoint.
  1. The node is displayed with a gray arrow in the Chart.
  2. The node is set as an entrypoint in the dialog.